内蒙古云计算产品专业运维
highway.blog.chinaunix.net
Brocade Command Line Interface
how to telnet to and use the command line on a brocade switch:
Basic Configuration
*** Initial Switch Commands and Setup ***
network IP interface settings
ipAddrShowipAddrSetNOTE:
before upgrading/downgrading Fabric OS, to preserve licenses on switch:
configUploadconfigDownload4016, 4018, 4020, 4024 sw mods for blade serverspod licenses from a pool of available licensesports will show No Sync or In Sync if no more licenses availableswitchShow to display port states
will erase any prior port license assignements if currently in static POD modelicensePort --method dynamicreboot (to restart and apply new mode)licensePort --show
portDisable (or portEnable slot#/port#)portEnable (or portEnable slot#/port#)
NOTE:
before connecting a swtich to a fabric that contains switches running diff fw versions, make sure PID format is the same on all switches
configShow (to check PID format)Gateway links
a gateway merges SANs into a single fabric by establishing point-to-point E_Port connectivity between two fibre channel switches that are sparated by a network with a protocol such as IP or SONET except for link initialization, gatewas are transparent to switches; the gateway simply provides e_port connectivity from on switch to another. by default, switchports initialize links using the exchange link parms (ELP) mode 1. however, gaeways expect initialization with ELP mode 2, also referred to as ISL R_RDY mode. Therefore, to enable two swithes to link thru a gateway, the ports onboth switches must be set for ELP mode 2
Any number of e_ports can be configured for gateway links, provided the follwoing guidelines are followed:
all switches in fabric must be upgraded to fabos v5.2.0 or laterall switches in fab are using cor PID formatswithes connected to both sides of gateway are included when determining switch count maximumsextended links (thos created using the extended fabrics licensed feature) are not supported thru gateway links.enter configShow on all switches to make sure PID format is consistent across entire fabric. If necessary,k change pid format on any nonconforming switchesconnect to switch at one end of gwportCfgIslMode ( or)repeat 1 thru 3 for any add'l portsrepeat procedure for switch at other end of gw
switchStatusPolicySetsetting value to 0,0 disables parm from being used to set overall status for switch
auditCfg --class 2,4 (which classes to filter)auditCfg --enable (audidCfg --disable to disable)auditCfg --show